Auxiliary Bench: Finished (Mostly)

A few final steps after glue-up remained to move the new bench to this state:

Those steps were:

  • Trimming the ends. I used a long-ish panel saw because it had the finest tooth pitch, in theory. Then I sanded coarse-medium-fine to get a smooth finish on the endgrain.
  • Flattening the top. This was the easiest thing I’ve ever done a flattening job on. Wish it were always like that.
  • Applying a quick finish, a varnish and tung oil blend. Yes, the tung oil is real tung oil, and yes, it takes forever to cure. I didn’t have any boiled linseed oil, and I didn’t care.

The two pieces of soft maple that I chose for the sides of the top are curly. I didn’t anticipate that, but I guess it looks fine. In this case, I only really cared if the grain reversed or not. On the front, it did not. On the rear, it did a little, but it doesn’t seem to be of much consequence.

This is the first somewhat large thing that I’ve made with southern yellow pine. I might post my thoughts on that later.

The size is a departure for me. I knew that it wasn’t going to be very long, but I also made it 33″ tall, which is a bit tall for someone my size. Well, at least for planing, but I don’t plan to plane much on this thing (I think it would work fine for small pieces, though).

Another note on the frame is that I made the side stretchers offset from the long ones on the front and rear. This allowed me to use longer tenons because they don’t meet in the middle of a leg, which I like. Wearing illustrates this in “The Solution At Hand,” though he uses through tenons.

I slapped on a temporary shelf and immediately loaded it up:

I hated this situation under my main bench, because the shavings and sawdust were always getting into the nooks and crannies of the planes. I’ll have less of that going on over here, so it should be a little better. I don’t expect the shelf to be there forever, though. I’d like to put a box of drawers in there, albeit one that doesn’t go anywhere near all the way to the top.

But I still don’t like it. I’m doing it now because these things were getting in the freakin’ way all of the time, but my thoughts are turning to the tool chest idea. It seems there’s a lot of merit in that, but I don’t have the time right now.

I probably won’t be working on much of anything wood-related for at least a week or so. There are some other things to take care of, but after that, I do have some plans to use this bench on a few diverse tasks.